| 1. | To discuss some problem in designing vacuum environment equipment
对热真空环模试验设备设计中有关问题的讨论 |
| 2. | The results showed that the given cable design could work normally under thermal vacuum environment
理论计算表明，给定的电缆设计满足在热真空条件下正常工作要求。 |
| 3. | Test method for total mass loss and collected volatile condensable materials from outgassing in a vacuum environment
在真空环境中除气作用引起的总物质损失及收集到的挥发性可凝聚物的试验方法 |
| 4. | Because field - emission devices have strict requirement for the vacuum environment , the vacuum performance of the field - emission cathode was very significant
由于真空场发射器件对于器件内部真空度的要求很严格,因此场发射阴极材料的真空性能非常重要。 |
| 5. | After the high altitude interceptor released from post - booster vechicle , part of its electrical cable from guidance bay to equipment bay worked in thermal vacuum environment
摘要高空制导飞行器从母舱释放后，制导舱与仪器舱之间部分电气电缆处于热真空条件下工作。 |
| 6. | The vacuum pump is used to provide a vacuum environment for the freezing - drying cabinet and the condensers so as to enable the moisture in the materials to sublimate in the vacuum
真空泵的作用是给冻干箱和冷凝器提供一个真空环境，使物料的水份可以在真空下进行升华。 |
| 7. | Aimed at the working characteristics of axial parts under high temperature and vacuum environment , this paper put forward a temperature controlling method for changing the partial thermal resistance of axial under the stable uneven temperature field
摘要针对高温真空环境下轴类零件的工作特点，提出了在稳定非均匀温度场下改变轴局部热阻的控温方法。 |
| 8. | This paper aimes to accomplish ignition start - up and steady work experiments in vacuum environment using different propellant and to find optimum propellant for engineering application of mpt finally based on analyzing , comparing and researching the experimental results
本文对不同的推进工质进行mpt点火启动实验及真空稳定工作实验研究，并对结果进行分析、比较和研究，最终为mpt工程应用寻找最合适的推进工质。 |
| 9. | To study the influence of the field - emission cathode materials for the vacuum environment of the field - emission devices , ambipolar electrode configuration was designed in this paper . cnts / ptfe and cnts / epoxy composite materials were used as field - emission cathode and the two electrode configurations were encapsuled into a static vacuum system respectively . by contrastive testing , the field - emission properties
3 .为了研究场发射阴极材料对场发射真空器件内部真空度影响的问题,设计二极电极结构,分别以碳纳米管/聚四氟乙烯和碳纳米管/环氧树脂两种复合材料作为场发射阴极,进行了真空封装,制成了静态的真空系统。 |
| 10. | This paper comparatively analyzes three more practical measurement methods of surface charge distribution on dielectric in vacuum environment : surface potential measurement method , electrostatic capacitive probe measurement method , pockels effect reflecting measurement method , expounds some newly researched productions , and at last puts forward some new problems to be solved in this field
摘要对比分析了真空中介质表面电荷分布测量中三类较实用的方法：表面电位法、静电容探头法、普克尔斯效应反射法，阐述了真空中介质表面电荷测量方法的研究新成果，最后提出了这一领域留待解决的新问题。 |
